点击次数：
所属单位：无人机研究院
发表刊物：Int J Adv Manuf Technol
摘要：In the present research, three typical cutting tool wear mechanisms (abrasive wear, adhesive wear, and diffusive wear) were taken into consideration in the FE simulation of cutting tool with a specific user-defined subroutine. Based on the influence of temperature on the cutting tool wear form, a novel wear rate model was built integrating Usui, Takeyama, and Attanasio wear rate equation. The high-speed cutting tests were carried out on Ti6Al4V to determine the proposed wear rate model constant. The cutting forces and rack face wear morphologies obtained from FE simulation match well with those from experimental cutting tests. Finally, the effect of cutting parameters on tool wear was studied by FEM. The simulation results show that the impact of the cutting speed on the cutting tool life is more significant than that of feed rate, and the preferred ranges of cutting speed and feed rate for extending cemented carbide cutting tool in high-speed dry cutting Ti6Al4V are 90–150 m/min and 0.10–0.20 mm/r, respectively. © 2019, Springer-Verlag London Ltd., part of Springer Nature.
ISSN号：0268-3768
是否译文：否
发表时间：2019-08-19
合写作者：苏宏华,Dai, Jianbo,Yang, Shubao
通讯作者：王阳