location: Current position: Home >> Scientific Research >> Paper Publications

Effects of preheating treatment on temperature distribution and material flow of aluminum alloy and steel friction stir welds

Hits:

Affiliation of Author(s):材料科学与技术学院

Title of Paper:Effects of preheating treatment on temperature distribution and material flow of aluminum alloy and steel friction stir welds

Journal:JOURNAL OF MANUFACTURING PROCESSES

Key Words:Friction stir welding Dissimilar welds Preheating treatment Temperature distribution Material flow

Abstract:Material flow and temperature distribution during welding are important factors that affect the properties of friction stir welding (FSW) joints. The scope of this investigation is to evaluate the effect of preheating treatment on the temperature distribution and material flow of aluminum alloy and steel joints produced by FSW. In this investigation, the finite volume model of butt FSW was established on basis of the FLUENT software. The flow of material during the FSW was simulated, and the temperature distribution in the FSW process was obtained by experiment and simulation. The effects of preheating treatment on the thermal history, temperature distribution, and material flow during FSW were elucidated in detail. The effects of preheating on the tensile strength and failure modes of the specimens were also discussed. The simulation shows that the preheating treatment increased the peak temperature of the steel, and also reduced the large temperature difference between the steel and the aluminum alloy in the high temperature stage. Simulation results, including temperature distribution and thermal history, were corresponded with the experimental results. The preheating treatment improved the flow velocities of the plastic materials and reduced the difference in flow velocities of the two materials. The preheating treatment could reduce the influence of the difference between the two materials on the forming of the welded joint and improve the property of the welded joint. (C) 2017 The Society of Manufacturing Engineers. Published by Elsevier Ltd. All rights reserved.

ISSN No.:1526-6125

Translation or Not:no

Date of Publication:2017-10-01

Co-author:Tang, Jingming

Correspondence Author:SHEN Yifu

Pre One:Friction stir spot welding ABS using triflute-pin tool: Effect of process parameters on joint morphology, dimension and mechanical property

Next One:Fabrication of ultra-thin copper foil pressure welding using FSW equipment